IP60H Custom Linear Actuator | OEM Configuration

IP60H custom linear actuator for OEM equipment

IP60H is positioned as a compact configurable linear actuator for OEM equipment. Final suitability depends on the selected electrical build, required load and stroke, travel speed, mounting geometry, feedback requirements, duty cycle, wiring and the real operating environment.

For system planning, compare IP60H with ActuLift aktuator linear 12V dan aktuator linear 24V. If the project has a defined dust, splash, washdown or outdoor requirement, review the aktuator linier tahan air category and request the applicable protection documentation for the exact actuator configuration.

Configuration data to confirm before quotation

• Required supply voltage and power-system limits.
• Required push and pull load in the real mechanism.
• Required stroke, retracted length and installation envelope.
• Required travel speed under the expected load.
• Expected operating frequency and duty cycle.
• Feedback, limit or position-signal requirements.
• Controller, cable, connector and wiring requirements.
• Required environmental or ingress-protection level.
• Required drawings, test records and compliance documentation.

Load, stroke and speed selection

Load, stroke and speed should be specified for the exact application rather than inferred from a generic product listing. Confirm the push and pull forces, side loads, installation angle, linkage geometry and expected peak loads before selecting the actuator build.

Stroke and speed also need to be checked together with the mechanical layout. Different gearing, loads and travel requirements can change the practical motion profile, so validate the complete mechanism during sampling.

Electrical and control matching

Confirm the supply specification, rated and peak current, switching method, cable length, connector capacity and controller interface for the selected IP60H build. If the project needs feedback or coordinated motion, confirm the exact sensor or signal arrangement before approval.

Related controller options can be reviewed under control boxes and controllers. Projects that require feedback should also review aktuator dengan umpan balik/pengontrol and validate the full actuator-controller combination.

Environmental and protection requirements

Environmental suitability is configuration dependent. Seals, cable exits, connectors, mounting direction and the surrounding equipment all affect the final result. If the project requires a specific ingress-protection level, temperature range, washdown method, outdoor exposure or chemical resistance, request the current supporting test basis or document for the exact ordered version.

Do not assume that the product family name or category alone proves a particular protection rating. The complete installation and the exact delivered configuration must be reviewed together.

Noise, life and duty-cycle validation

For equipment used near people, define an acceptable sound target and test the actuator in the finished structure. Mounting stiffness, frame resonance, load and guide alignment can materially change the sound of the complete system.

Service life and duty cycle should be validated against the real ON/OFF pattern, load and ambient conditions. Request the applicable test basis or supplier documentation if a project requires a defined lifecycle or continuous-operation limit.

Compliance and documentation

For export programs, regulated equipment or customer quality systems, request the documentation package for the exact IP60H configuration. Depending on the project, this may include drawings, product specifications, inspection records, material information, environmental test evidence or available compliance declarations.

Do not treat generic page wording as proof that a certification or standard applies unchanged to every configuration or to the buyer’s finished machine. Final requirements depend on the ordered build and destination market.

Daftar periksa pembeli OEM

• Confirm the exact actuator configuration before sample approval.
• Confirm load, stroke, speed and mounting requirements from the real mechanism.
• Confirm supply, current, wiring, connectors and controller compatibility.
• Confirm feedback or limit requirements where applicable.
• Confirm environmental/protection requirements with supporting documentation.
• Confirm duty-cycle and lifecycle requirements from the actual use case.
• Confirm the documentation package required before bulk approval.

Where IP60H fits

IP60H is best treated as a configurable compact actuator platform for OEM projects rather than a fixed universal specification. Use the product page to start the sourcing conversation, then lock the exact electrical, mechanical, environmental and documentation requirements through drawings, samples and project-specific validation.

Related ActuLift resources

• aktuator linier tahan air
• aktuator linear 12V
• aktuator linear 24V
• Kotak kontrol dan pengontrol
• Actuators with feedback/controller
• Brackets and mountings